A small percentage of shipbuilders, particularly northern European and North American area, it features regularly on the shaft stands equipped with terminal bar bushings.
This joke, when replacing the bearing idrolubrificato, forcing the removal of axles, and steering racks. The use of dampers, if it is not possible, unless you permanently remove the joke.
Note that, even bringing in the media workshop, you can not pull off the presses bushing, threaded rods or other instruments in this case the only system that applies is the manual cutting of the bush with a hacksaw and the retaliation of the shell in order to remove the piece from the stand.
Unless you remove the bar, as already mentioned, this procedure should be repeated at the subsequent replacement of the bushing.
0 comments:
Post a Comment